A-Jax D’azur PLA / PDLLA Filler – 200mg


A-Jax D’azur is a highly effective deep wrinkle and skin fold filler, based on Poly DL-Lactide. PLA fillers like D’azur are powerful collagen production stimulators. While offering immediate volumization effect they, also,  gradually boost the levels of collagen in the area of treatment, restoring volume in a natural and very lasting way. A-Jax  D’azur offers a long term skin smoothing with imperceivable results, as depressions of the skin are filled using collagen synthesized by the dermis.

5+ rate10+ rate20+ rate30+ rate40+ rate

get callback

Sale Banner

Items are shipped in 6 to 48 hours after the payment clears
(not counting weekends and holidays)


Wrinkles, skin folds and overall loss of volume in certain areas are an inevitable part of the aging process, which is often amplified by factors such as stress, fatigue, bad diet, air pollution and sun overexposure. All of these combined lead to a rapid decline of collagen and elastin in the dermis, as well as degradation of the supportive tissues of the skin. The result is the formation of visible skin depressions, as well, as noticeable sagging.

Standard dermal fillers, specifically ones based on Hyaluronic acid, focus on only the volumizing effect and have limited long term benefits to the dermis, outside of some improved hydration. A-Jax Dazur filler goes beyond that. Once the filler is dissolved and the preparation is ready, a CMC gel is formed which will fill the skin folds immediately. This gel is, over time, absorbed into the dermis leaving PLA microspheres in the treated area, which induce skin regeneration and skin cell formation into the space where the CMC gel was. The new dermal cells increase the local synthesis of collagen for long term volumuzation and skin surface smoothing.

Ajax D’azur is one of the safest collagen fillers on the market. It’s a direct alternative to the Aesthefill, offering similar quality, but at an even lower price range. It is 100% biocompatible and biodegradeable as both the CMC (Sodim Carboxymethyl Cellulose) and the PLA (Poly DL-Lactide) are naturally absorbed by the skin, over time, with virtually no adverse reactions.


  • Immediate filling effect
  • Boosts collagen production
  • Induces skin cell regeneration
  • Longer volumizing effect
  • Very low adverse reaction rates

Additionally, preparing the solution takes only 60 minutes, as opposed to traditional PLLA and PDLLA / PLA fillers. The actual procedure for application is normally within 30 minutes.

The A-Jax D’azur collagen boost filler can be used for both the face and the body. Depending on the area, facial application must be done into the subcutaneous, supra-periosteum or submental submandibula dermal layer, using the liner, depot or panning method, respectively. In terms of body usage, it can be applied in the hip and buttocks area to restore the natural elasticity and add long term volume to the treated area, by boosting local collagen synthesis and skin cell generation.

In general, the usage protocol is similar to Aesthefill, but be sure to read the instructions included in the box for application, counterindications, possible adverse reactions etc. The exact method of application is determined by the dermatologists or other licensed practitioner performing the procedure.

Additional information

Weight 0.05 kg

Disclaimer: Always read the detailed ingredients list on the back of the box or inside the included booklet. Be sure to read the included leaflet in regard to intended usage, proper application, safety procedures and, if applicable, possible counter indications and/or adverse effects. Make sure you are not allergic to any of the ingredients (certain products contain Lidocaine).